Skip to content
FALCON CORETECHNOLOGIES

// Lesson 32 of 49 · IP routing

First hop redundancy (HSRP, VRRP, GLBP)

Giving hosts a default gateway that survives a router failure — virtual IPs, active/standby roles and HSRP configuration.
2 min read#hsrp#vrrp#glbp#redundancy

A host has one default gateway address. If that router fails, the host loses everything beyond its subnet — even when a second router is right there. A first hop redundancy protocol (FHRP) fixes this by sharing a virtual IP and virtual MAC between routers.

How it works

  • Two (or more) routers share a virtual IP, for example 192.168.10.1, which hosts use as their gateway.
  • One router is active and answers for the virtual IP and MAC; another is standby.
  • They exchange hellos. If the active router disappears, the standby takes over the virtual IP and MAC within seconds. Hosts notice nothing — their ARP entry is still valid.

The three protocols

HSRP VRRP GLBP
Standard Cisco Open (RFC 5798) Cisco
Roles Active / Standby Master / Backup AVG + several AVFs
Load sharing Per group (use several groups) Per group Built in — several routers forward at once
Virtual MAC (IPv4) 0000.0c07.acXX (v1) / 0000.0c9f.fXXX (v2) 0000.5e00.01XX 0007.b400.XXYY
Pre-emption Off by default On by default Off by default

HSRP configuration

R1(config)# interface GigabitEthernet0/0
R1(config-if)# ip address 192.168.10.2 255.255.255.0
R1(config-if)# standby version 2
R1(config-if)# standby 10 ip 192.168.10.1
R1(config-if)# standby 10 priority 110
R1(config-if)# standby 10 preempt

R2(config)# interface GigabitEthernet0/0
R2(config-if)# ip address 192.168.10.3 255.255.255.0
R2(config-if)# standby version 2
R2(config-if)# standby 10 ip 192.168.10.1
  • The highest priority (default 100) becomes active; ties go to the highest interface IP.
  • Preempt lets the preferred router take the active role back after it recovers.
  • The group number (10) must match on both routers.

Verify

R1# show standby brief
                     P indicates configured to preempt.
Interface   Grp  Pri P State   Active          Standby         Virtual IP
Gi0/0       10   110 P Active  local           192.168.10.3    192.168.10.1

Test failover: shut R1's interface and keep a continuous ping running from a host (ping -t 8.8.8.8 on Windows) — you should lose only a couple of replies.

Key points

  • Hosts use a virtual IP; routers share it with a virtual MAC.
  • HSRP: active/standby, priority 100 by default, pre-emption off by default.
  • VRRP is the open standard; GLBP load-balances across routers.
  • Configure the same group and virtual IP on all members.

Sign in to save your lesson progress across devices. You can read every published lesson without an account.