Skip to content
FALCON CORETECHNOLOGIES

// Lesson 18 of 49 · Switching and VLANs

VLANs and access ports

Why VLANs exist, creating them, assigning access ports, voice VLANs, and verification.
2 min read#vlan#switching

A VLAN splits one physical switch into several logical switches. Devices in different VLANs cannot talk to each other without a router, even when they are plugged into the same switch.

Why use VLANs

  • Smaller broadcast domains — less unnecessary traffic.
  • Security and policy — separate staff, guests, servers, cameras; filter between them at the router or firewall.
  • Flexibility — group users by role, not by where their desk is.

VLAN numbers

Range Notes
1 Default VLAN; every port starts here. Do not use it for users.
2–1001 Normal range
1002–1005 Reserved for legacy Token Ring / FDDI
1006–4094 Extended range

Create VLANs and assign access ports

SW1(config)# vlan 10
SW1(config-vlan)# name STAFF
SW1(config-vlan)# vlan 20
SW1(config-vlan)# name GUEST
SW1(config-vlan)# exit

SW1(config)# interface range GigabitEthernet1/0/1 - 12
SW1(config-if-range)# switchport mode access
SW1(config-if-range)# switchport access vlan 10

SW1(config)# interface range GigabitEthernet1/0/13 - 20
SW1(config-if-range)# switchport mode access
SW1(config-if-range)# switchport access vlan 20

If you assign a port to a VLAN that does not exist yet, newer IOS versions create it automatically — but name your VLANs explicitly.

Voice VLAN

An IP phone and a PC often share one wall port: the PC plugs into the phone. The port carries the PC's traffic untagged in the access (data) VLAN and the phone's traffic tagged in a separate voice VLAN:

SW1(config)# interface GigabitEthernet1/0/5
SW1(config-if)# switchport mode access
SW1(config-if)# switchport access vlan 10
SW1(config-if)# switchport voice vlan 110

The phone learns the voice VLAN through CDP or LLDP.

Verify

SW1# show vlan brief
VLAN Name                             Status    Ports
---- -------------------------------- --------- -------------------------------
1    default                          active    Gi1/0/21, Gi1/0/22, Gi1/0/23
10   STAFF                            active    Gi1/0/1, Gi1/0/2, ... Gi1/0/12
20   GUEST                            active    Gi1/0/13, ... Gi1/0/20

SW1# show interfaces GigabitEthernet1/0/5 switchport

Note: trunk ports do not appear in show vlan brief — use show interfaces trunk.

Common mistakes

  • Port in the wrong VLAN → the host gets an address from the wrong DHCP scope or none.
  • VLAN exists on one switch but not on the next → traffic does not cross the trunk.
  • VLAN shut down (shutdown under the VLAN) or suspended.

Key points

  • VLAN = separate broadcast domain; inter-VLAN traffic needs routing.
  • switchport mode access + switchport access vlan N.
  • Voice VLAN: data untagged, phone traffic tagged.
  • show vlan brief for access ports, show interfaces trunk for trunks.

Sign in to save your lesson progress across devices. You can read every published lesson without an account.