Skip to content
FALCON CORETECHNOLOGIES

// Lesson 24 of 49 · Wireless LANs

Wireless fundamentals

802.11 standards, the 2.4, 5 and 6 GHz bands, channels, SSIDs and BSSIDs, and why Wi-Fi behaves differently from Ethernet.
2 min read#wireless#802-11#rf

Wi-Fi replaces the cable with radio. That changes three things: the medium is shared, it is half duplex (one station transmits at a time on a channel), and anyone in range can receive the signal.

802.11 generations

Standard Wi-Fi name Bands Notes
802.11n Wi-Fi 4 2.4 / 5 GHz MIMO, channel bonding
802.11ac Wi-Fi 5 5 GHz Wider channels, MU-MIMO (downlink)
802.11ax Wi-Fi 6 / 6E 2.4 / 5 / 6 GHz (6E) OFDMA, better in dense areas
802.11be Wi-Fi 7 2.4 / 5 / 6 GHz Multi-link operation, very wide channels

Bands and channels

  • 2.4 GHz — longer range, better through walls, but crowded. Only three non-overlapping 20 MHz channels: 1, 6 and 11 (in most regions).
  • 5 GHz — many more non-overlapping channels, less interference, shorter range.
  • 6 GHz — available to Wi-Fi 6E/7 devices; very clean spectrum, shorter range again.

Neighbouring APs should use non-overlapping channels; two APs on the same channel share airtime, slowing both.

Coverage terms

  • SSID — the network name users see.
  • BSS / BSSID — one AP radio serving clients; the BSSID is that radio's MAC address.
  • ESS — several APs with the same SSID, allowing clients to roam.
  • IBSS — ad hoc, device to device, no AP.

Signal basics

  • Signal strength is measured in dBm (negative numbers; −50 is strong, −80 is weak). A common design target for data is about −67 dBm or better.
  • SNR (signal-to-noise ratio) matters as much as strength.
  • Walls, metal, water (people!) and distance all weaken the signal; microwaves and Bluetooth interfere in 2.4 GHz.

Medium access

Wi-Fi uses CSMA/CA: a station listens before sending and waits a random time if the channel is busy. Every unicast frame is acknowledged; lost frames are retransmitted. This is why Wi-Fi throughput is always lower than the advertised data rate.

Key points

  • Wi-Fi is shared and half duplex; anyone in range can hear it.
  • 2.4 GHz non-overlapping channels: 1, 6, 11.
  • SSID = name; BSSID = AP radio MAC; ESS = many APs, one SSID.
  • Signal in dBm (closer to 0 is stronger); aim for about −67 dBm.

Sign in to save your lesson progress across devices. You can read every published lesson without an account.