Skip to content
FALCON CORETECHNOLOGIES

// Lesson 15 of 49 · IPv6

Configuring IPv6 on Cisco routers

Enabling IPv6 routing, assigning addresses, verifying neighbours and routes, and static IPv6 routing.
2 min read#ipv6#ios#configuration

Enable IPv6 routing

IOS routers forward IPv6 only after you enable it globally:

R1(config)# ipv6 unicast-routing

Without this command, the router still has IPv6 addresses but behaves like a host: it does not route IPv6 or send Router Advertisements.

Assign addresses

R1(config)# interface GigabitEthernet0/0
R1(config-if)# ipv6 address 2001:db8:acad:10::1/64
R1(config-if)# ipv6 address fe80::1 link-local
R1(config-if)# no shutdown

R1(config)# interface GigabitEthernet0/1
R1(config-if)# ipv6 address 2001:db8:acad:12::/64 eui-64
  • Setting a simple link-local address such as fe80::1 makes routing tables and troubleshooting much easier to read.
  • eui-64 builds the interface ID automatically from the MAC.
  • ipv6 enable creates only a link-local address.

Verify

R1# show ipv6 interface brief
GigabitEthernet0/0     [up/up]
    FE80::1
    2001:DB8:ACAD:10::1
R1# show ipv6 neighbors
R1# show ipv6 route

show ipv6 interface GigabitEthernet0/0 also lists the multicast groups the interface has joined (ff02::1, ff02::2, solicited-node).

Static IPv6 routes

The syntax mirrors IPv4:

! next hop = neighbour's global address
R1(config)# ipv6 route 2001:db8:acad:30::/64 2001:db8:acad:12::2

! next hop = link-local: the exit interface is required
R1(config)# ipv6 route 2001:db8:acad:30::/64 GigabitEthernet0/1 fe80::2

! default route
R1(config)# ipv6 route ::/0 GigabitEthernet0/1 fe80::2

A link-local next hop needs the exit interface because the same fe80:: address could exist on every link.

Testing

R1# ping 2001:db8:acad:30::10
R1# traceroute 2001:db8:acad:30::10
C:\> ping -6 2001:db8:acad:30::10

Dual stack

Most networks run dual stack: IPv4 and IPv6 on the same interfaces at the same time. Each protocol has its own addresses, routing table and routing protocol process. Configure and verify them independently.

Key points

  • ipv6 unicast-routing turns a router into an IPv6 router.
  • Configure memorable link-local addresses (fe80::1) on router interfaces.
  • show ipv6 interface brief, show ipv6 route, show ipv6 neighbors.
  • Static routes with a link-local next hop need the exit interface.

Sign in to save your lesson progress across devices. You can read every published lesson without an account.